+ 86-23-63089919 send a message                  

Hydrostatic Pipe Test Pumps

by:Wingoil     2020-09-10

Hydratron is a trusted producer of high strain and circulate control equipment, broadly recognised for the flexibility to create revolutionary high-high quality solutions. Inject the Water – Water as per the standards talked about above ought to be used for hydrostatic inspection. This water ought to be injected on the specified stress, volume, and temperature. Support for Pipes – Sometimes hydro testing is carried out on the sites, however many firms favor to execute it at an area close to the fabrication yard so that any anomalies can be ameliorated instantly.

For example, if check pressure is one thousand PSI, the most effective pressure gage for testing will be 2000 PSI stress gage. As per above requirements the 1200 PSI and 5000 PSI strain gages will not be acceptable. The hydrostatic testing shall be carried out by calibrated strain gage, and the inspector shall verify the calibration and expiration dates. The preferable vary of strain gage shall be twice of the check strain but in no case shall be less than 1.5 occasions and not more than 4 times of the test stress. The pump casing cooling water passages, (if any) bearing jackets and seal chamber, and so forth. shall be tested at minimal one hundred fifty PSI.

Both the electrical and diesel hydrostatic testers are designed for optimum portability, being offered on a skid or trailer. The Gardner Denver testers combine unsurpassed performance, reliability and flexibility in a single competitively priced workhorse. With countless enhancements and choices, it’s everything you’ve come to anticipate from Gardner Denver.

Low, medium & excessive stress equipments to be used in all industries with a variable pressures as much as 70,000 Psig. Gardner Denver presents essentially the most comprehensive suite of hydrostatic testing equipment available available on the market at present.

It is important to choose proper support, stand or sleepers to suspend pipes earlier than hydrostatic tests begin. The stands ought to have the ability to withstand the weight and length of the pipeline. Hydra or Crane – The pipelines can be as huge as one hundred twenty inches in diameter and even more dependent on the volume of liquid passing via it. So, transportation tools like Hydra and crane must be used to raise and place the pipeline on the support or a chosen place. It is critical that the security department certifies the belt and riggers dealing with the pipes and that only certified and competent executives operate the Hyrda or crane.

For easy processes, it is very important check them after production or during upkeep phases. The hydrostatic stress take a look at subjects the specimens to tightness and power tests at pressures of up to 3,000 bar. If pressurization time is not critical the operator can select to run one pump solely and hold the second pump as a back up. This is usually a requirement when hydrostatic testing offshore when downtime caused by pump failure may be very costly.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...