info@wingoil.com         +86-23-63089919         Send A Message

Leaders In Pressure Control Equipment

by:Wingoil     2020-08-28

Testing is critical for storage and transport equipment because such containers can explode if they fail underneath pressure. Operating an injection properly with open tubing-casing wellhead valves is an unsound apply because a tubing or packer failure will result in instant surface and subsequent, groundwater air pollution. Anyone who is permitted by the well operator can carry out the standard H-5 stress test. There isn't any requirement to rent a service or testing firm to perform the check. Alternatively, UIC might approve the usage of air strain to check the tubing/casing annulus.

In this case, the directions on Form H-5 would nonetheless be adopted, except that the check strain would have to stabilize for at least 60 minutes. Wells that inject liquids are required by rule to test with a liquid stuffed annulus. Thetwo-half strain take a look at could also be performed as described within the seminar manual.

The testing cables are custom made with an integrated precision transducer that ties into the strain testing port. These cables and place of the sensor, located near the pressure testing port, eliminates the pressure drop usually associated with measuring pressure at or near the truck. The BOPX Truck System is a turnkey pressure testing solution.

Additionally the BOPX Truck System features our patent pending EZ Press check technique. The EZ Press test technique can detect leaks as small as a few cc/min throughout the first 60 secs of the pressure hold cycle. This helps to establish potential failing leaks nicely before the normal 5 to 10 min ready interval of typical strain decay take a look at. This tool works good I even have about 10 completely different ones from cta they are all good high quality no problems even with completely different mechanics using it in my store on a regular basis.

The use of a tubing plug may be necessary if the take a look at strain cannot be achieved as a result of low shut in tubing strain or low injection stress. Under most operating conditions, this may point out a scarcity of adequate mechanical integrity and the well would have to be shut in, repaired, and retested. In uncommon instances by which a well operates at low injection pressures and volumes with full surface casing protection of usable high quality groundwater, UIC could allow continued operation of the well topic to frequent retesting and monitoring. All injection and disposal wells should reveal mechanical integrity.

If it is not completely apparent you want the Stant strain tester to work with this . Hydrostatic testing is the commonest approach to test if there’s a leak in pressure containing equipment and helps keep security standards and durability of pipelines or storage vessels over time.

I'm principally pointing to the adapters, I've by no means tried them earlier than but they appear like an excellent resolution. I purchased the Heavy truck adapters package whick works with all the Macks, F liners, pete's and kitty whompers Ive seen. costs over 200 although so, I woulda rather bought the increasing adapters in the event that they were obtainable again then.

The BOPX Truck System provides exact automated pressurization management mitigating the unpredictability of personnel and the manual pressurization course of. This allows for a predictable, repetitive strain testing process which reduces overall test instances.
Custom message
Chat Online 编辑模式下无法使用
Chat Online inputting...